ICP DAS USA I-8092F Getting Started Manual page 15

CON4
The connector CON4 is 16-pin connector that enables you to connect to the signals of
your motor drivers. Fig.2-4 shows the pin assignment for the 11-pin connector on the
DN-8237-GB, and the Table 2-4 shows its I/O connector signal description.
TB1
The connector TB1 is 5-pin connector that enables you to connect to the signals of your
motor drivers. Fig.2-4 shows the pin assignment for the 5-pin connector on the
DN-8237-GB, and the Table 2-4 shows its I/O connector signal description.
http://www.icpdas.com 15
I8092F Getting Started ManualVer.2.3