ICP DAS USA I-8092F Getting Started Manual page 18

Pac motion control module

Hide thumbs Also See for I-8092F:

Table of Contents

JP1/2 & JP3/4

Jumper 1, 2 controls the XPP, XPM signals of the CON2. The couple of jumpers are

indicated the type of pulse output signal for X axis. However there are the same jumper

settings for Y axis (Jumper 3, 4 for Y axis). The following diagram is shown the selection

condition of the jumper 1, 2.

Fig. 3-9 Jumper 1, 2 setting

http://www.icpdas.com

I8092F Getting Started ManualVer.2.3

Table of Contents