RJ1 (The I/O signals of the FRnet)
The connectors RJ1 is an 8-pin RJ45 connector that enable you to connect to the signals
of FRnet. Fig.3-5 shows the pin assignment for the 8-pin connector on the DN-8237-GB,
and the Table 3-5 shows its I/O connector signal description.
2.2.3 Jumper and Switch Settings
JP5
Jumper 5 controls the EMG-A signal of the CON4 connector. The following diagram is
shown the selection condition of the jumper 5.
http://www.icpdas.com
Fig. 3-6 Jumper 5 setting
16
I8092F Getting Started ManualVer.2.3