Table of Contents
Advertisement
7
Appendix
7.1 Software Configuration Mode
Each ZT-2000 I/O device contains a built-in EEPROM memory that is used to
store configuration information, such as the address, the data format, the AI
type code and other information. When the module is powered on with
Address(Node ID) set to 0x00, the ZT-2000 I/O device will be set to the software
configuration mode. In this mode, the configuration(Address(Node ID), data
format and AI type code) are loaded from the EEPROM. The settings can then be
changed using the %AANNTTCCFF, and $AA7CiRrr commands. When the
ZT-2000 I/O device is set to software configuration mode, the switch settings
are ignored.
Page 131
ICP DAS, ZT-2017 and ZT-2017C AI Series User Manual, Version 1.0.1
Copyright © 2012 by ICP DAS Co., Ltd. All Rights Reserved.
Advertisement
Table of Contents
