ICP DAS USA I-8092F Getting Started Manual page 53

Pac motion control module

Hide thumbs Also See for I-8092F:

Table of Contents

SW 1

The emergency stop signal for each servo ampilfier can be selected from SW1. The

number 1 and 2 on SW1 are denoted as axis X and Y, respectively. The number 3 and 4

on SW1 are reserved for future work. Fig. B1-9 is the default setting to connect the EMG

singals to GND. The EMG signals from CN1 and CN2 will not take effect. If the switch is

disconnected as shown in Fig. B1-10, the emergency stop signals can be controlled from

EMG signals in CN1 and CN2.

Fig. B1-9 SW1 setting for normally GND (Default setting)

Fig. B1-10 SW1 setting for user controlled signals.

http:/www.icpdas.com

I8094Getting Started Manual for WinPAC Ver.1.1

Table of Contents