Encoder Signals; Emergency Stop Signal - ICP DAS USA I-8092F Getting Started Manual

Pac motion control module

Hide thumbs Also See for I-8092F:

Table of Contents

2.3.4 Encoder Signals

The following diagram is for Differential-Type encoder signals.

Connect the

Phase A signal to A+ and A- pins and connect Phase B signal to B+ and B- pins.

After the high speed photo coupler isolation, the isolated encoder signals are

connected to motion IC.

Fig. 2.13 Encoder signal connection

The following diagram is for Emergency STOP signal. If the emergency signal is

occurred, the output pulse for all axes will be STOP and the error flag will be set as

1. After the photo coupler isolation, the isolated emergency signal is connected

to motion IC.

Fig. 2.14 Emergency Stop Signal connection

http://www.icpdas.com

I8092F Getting Started ManualVer.2.3

Table of Contents