Install I-8092F Software Into Winpac - ICP DAS USA I-8092F Getting Started Manual

3.2.2 Install i-8092F software into WinPAC

The necessary files for WinPAC now are packed into one CAB file. In WinPAC,
double-click the CAB file will start installation automatically. The files then will be copied
into the specific directories.
When the installation is completed, the driver and library will be copied into the specific
directory defined in XPAC_CE. And the relevant utilities are installed into
\System_Disk\i8092.
［Notice］
WinPAC supports addon driver after OS Ver.1.3.0.0. Please check the OS version of target
WinPAC.
The utilities are:
MotionCfg – To configured the i8094/F and i8092F in XPAC_CE. When XPAC_CE
booting up, the OS will refer to those configuration and activate the relative i-8092F
modules.
i8092F EzGo – Provide the similar features of PISO-PS200 EzGo utility. This utility
helps to indicate the status of each axis, configure the polarity of external sensors
and demonstrate the basic/simple motion-controlling models.
i8092F EzFRnet – Demonstrate the FRnet features.
http://www.icpdas.com 29
I8092F Getting Started ManualVer.2.3