Table of Contents
Advertisement
3. Insert the simple swap hard disk drive into the drive tray assembly.
4. Slide the drive into the bay until the rear of the drive snaps into place with the
5. Install the filler panel for the drive.
6. If you have other options to install or remove, do so now.
7. Go to "Completing the installation" on page 44.
Removing and installing an internal DVD-ROM drive or DVD-ROM
blank bezel
The following notes describe the type of DVD-ROM drive the server supports and
other information that you must consider when installing a DVD-ROM drive:
v The server supports the installation of an optional DVD-ROM drive only when
v The DVD-ROM drive must be a slim 9.5 mm drive and you install it underneath
If you are removing an internal DVD-ROM drive or blank bezel, continue with
"Removing an internal DVD-ROM drive or DVD-ROM blank bezel" on page 27. If
you are installing an internal DVD-ROM drive or blank bezel, go to "Installing an
internal DVD-ROM drive or DVD-ROM blank bezel" on page 29.
Removing an internal DVD-ROM drive or DVD-ROM blank bezel
Complete the following steps to remove an internal DVD-ROM drive or DVD-ROM
blank bezel:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Turn off the server and peripheral devices and disconnect all power cords and
Note: To make sure there is adequate system cooling, do not operate the
server for more than 2 minutes without either a hard disk drive or a filler
panel installed in each bay.
rear panel-mount connector. This simple swap connector contains the signal
and power connections that are needed by the SATA drive.
you are using a 3.5-inch hard disk drive configuration.
the 3.5-inch hard disk drive, on the left side.
Note: DVD-ROM, CD-ROM, and diskette drives can also be attached externally
using the USB connector.
page 13.
external cables (see "Turning off the server" on page 15); then, remove the
cover (see "Removing the server cover" on page 17).
Chapter 2. Installing options
27
Advertisement
Table of Contents
