Installing A Switch Using The Rkmt-J14 Rack Mount Kit; What To Prepare; Installing A Switch Using The Rack Mount Kit - Allied Telesis GS910/XST Series Installation And User Manual

Installing a Switch Using the RKMT-J14 Rack Mount Kit

What to Prepare

Installing a
Switch Using the
Rack Mount Kit
This section shows you steps to install a switch in an equipment rack using
the RKMT-J14 kit.
Before installing a switch to an equipment rack, make sure that the
following items are ready.
Two RKMT-J14 rack mount brackets

Two RKMT-J14 handles

Four M3x6mm screws

Eight M4x6mm screws

Four screws for the equipment rack (not included)

Phillips-head screw driver (not included)

To install a switch in a rack using the RKMT-J14 rack mount kit, perform
the following procedure:
1. Review "Reviewing Safety Precautions" on page 32 and "Selecting a
Site for the Switch" on page 34 before performing this procedure.
2. Place all the items from the packaging on a work table.
3. Attach the handles to the brackets as shown in Figure 36.
Figure 36. Attaching the Handles to the Brackets
Chapter 6: Rack Installation Using the RKMT-J14 Kit
69