Installing A Fan; Removing The System-Board Battery - IBM 7940 Problem Determination And Service Manual

2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server cover (see "Removing the cover" on page 31).
4. Disconnect the cable of the failing fan from the connector.
5. Lift the fan out of the server.
6. If you are instructed to return the fan, follow all packaging instructions, and use

Installing a fan

Alignment pins
Attention:
failed fan.
To replace a fan, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Push the fan assembly down into the server until it seats.
3. Connect the cable of the replacement fan to the connector.
4. Install the cover (see "Installing the cover" on page 31).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.

Removing the system-board battery

To remove the system-board battery, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server cover (see "Removing the cover" on page 31).
external cables; then, remove the server from the rack.
any packaging materials for shipping that are supplied to you.
To ensure proper server operation, do not operate the server with a
on page 29.
on page 29.
external cables; then, remove the server from the rack.
Chapter 4. Removing and replacing server components
43