Removing The System Battery - IBM System x3550 M4 Installation And Service Manual

Removing the system battery

Use this information to remove the system battery.
About this task
The following notes describe information that you must consider when replacing
the battery.
v IBM has designed this product with your safety in mind. The lithium battery
v If you replace the original lithium battery with a heavy-metal battery or a
v To order replacement batteries, call 1-800-IBM-SERV within the United States,
To remove the system battery, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Remove the cover (see "Removing the cover" on page 36).
4. If necessary, lift the PCI riser-card assembly 2 out of the way (see "Removing a
294
IBM System x3550 M4 Type 7914: Installation and Service Guide
must be handled correctly to avoid possible danger. If you replace the battery,
you must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
battery with heavy-metal components, be aware of the following environmental
consideration. Batteries and accumulators that contain heavy metals must not be
disposed of with normal domestic waste. They will be taken back free of charge
by the manufacturer, distributor, or representative, to be recycled or disposed of
in a proper manner.
and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, contact your IBM sales representative or IBM reseller.
Note: After you replace the battery, you must reconfigure the server and reset
the system date and time.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
– Throw or immerse into water
– Heat to more than 100°C (212°F)
– Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
"Installation guidelines" on page 33.
all external cables, if necessary.
PCI riser-card assembly" on page 244).