Table of Contents
Advertisement
3. NAME OF EACH PART AND PREPARATION FOR TRIAL RUN
(1) Operating switches
!2
1 Power switch
Use this switch to turn ON/OFF the power to the unit.
(If installing the optionally available MC-6,use independent power for the MC-16 that is located on
section A on the right-hand side of the main unit.)
2 Emergency stop switch
Use this switch to stop the machine from running.
3 Knee switch
This switch is used as the start switch.
4 Hand switch
This switch is used as the work clamp release switch.
5 Feeder switch
6 Button feeder switch
Used to supply buttons to the button clamp jaw lever.
7 Set-up switch
This switch is used for operating the spinner oscillating arm under the step-operation mode. The spinner
oscillating arm performs step operation as long as the switch is held pressed.
8 Button discharging switch
This switch is used to discharge buttons in the index unit.
9
6
7
8
3
4
−
−
5
1
!0
!1
4
A
2
Advertisement
Table of Contents
