Table of Contents
Advertisement
3) Centering the positioning until
4
3
2
1
4) Replacing and positioning the feed disk
ø16
Pan
* Turn over the pan, and buttons of which size is
ø22 can also be used.
Align the matchmarks.
Feed disk
Triple pawl
Shutter magnet
6
5
7
ø22
Pinion
Feed disk
−
1) Loosen bolts 1 and check bolt 6 of the shutter
magnet support plate.
2) Fit centering ring 3 in the center of triple-pawl 2.
Draw out triple-pawl dog 5 to allow centering ring
3 to be fitted in place. Move the index base plate
7 until a position where the rotary rod 4 (with the
work attachment removed) smoothly enters
centering ring 3 is reached.
3) After the positioning unit is correctly centered,
tighten bolts 1 and 6.
(Caution) Be sure to check again that the
positioning unit has been properly after
tightening bolts 1.
1) Pan
Use the feed disk (standard) of ø16 for buttons of
which size is ø10 to ø15. When buttons of which
size is ø16 to ø18 are used, use the feed disk
(optional) of ø22. In this case, adjust the pan located
under the feed disk according to the diameter of
the hole in the feed disk. Ten pan has two holes,
one is ø16 and the other is ø22. Bring the hole of
ø16 for the feed disk of ø16 or the hole of ø22 for
the feed disk of ø22 this size of the pan in terms of
the direction of rotation of the feed disk by turning
over the pan.
2) To position the feed disk, check first that the pinion
is in its origin. Then adjust the position of the feed
disk so that the matchmark on the feed disk aligns
with the matchmark on the pinion (countersinking).
At this time, align the hole in the pan with the hole
in the feed disk on the triple pawl.
3) Take the value obtained by adding 1 mm to the
buttonhole diameter in the feed disk used as
criterion of the initial diameter of the triple pawl.
Adjust the initial diameter of the triple pawl using
the positioning stopper bolt.
59
−
Advertisement
Table of Contents
