Table of Contents
Advertisement
4 Adjisting the set plate
5
6
1. Adjusting the height of the set plate
0
4
mm
– 2
2
7
Loosen screws in set plate support fixing plate 7 and
set plates support (right and left) 3 and 4, and adjust
the height of the set plates to 1±0.5 mm above the top
surface of the throat plate by moving set plate support
(right and left) 3 and 4 and rail installing plate support
5 up or down.
Then check that the specified height of 1±0.5 mm is
provided at both ends and center of the respective set
plates.
0
4
mm
– 2
50
−
7
4
1 Set plate (right)
2 Set plate (left)
3 Set plate support (right)
4 Set plate support (left)
5 Rail installing plate support
6 Set plate installing base
7 Set plate support fixing plate
(Caution)
Be sure to turn OFF the power to the machine
before adjustment.
−
1
7
3
Advertisement
Table of Contents
