Table of Contents
Advertisement
2. Adjusting the position of the scale on the set plates
6
B
9
1) Adjusting the gauge (left)
Confirm that dimension A provided from the center of the needle to gauge (left) 2 is equal to the value
shown on the scales on both sides. If the value shown on the respective scales is different from dimension
A, loosen first screw 5 and the screws in collars 6, and move set plate (left) 9 in the direction of the
arrow until the scales are correctly positioned. At this time, use the rightmost end of set plate (left) 9 as
reference and adjust the leftmost end to it.
(It is recommended to adjust distance B provided between gauge (left) 2 and clamp support plate (left)
7 equally at both ends when the clamp support plate (left) 7 moves laterally.)
2) Adjusting the gauge (right)
After the completion of the adjustment of the gauge (left),adjust the position of gauge (right) 1 so that
"A' equals to A". Then fix the gauge (It is recommended to fit a straight ruler or the like against the gauge
surface.) Then, loosen screws 4 in scale plates 3, and adjust so that the value read at section D
equals to A. Move clamp support plate (right) 8 to the right and left and measure dimension C at the
rightmost end and the leftmost end of the travel so as to confirm that equal adjustment value is provided
both at the rightmost end and the leftmost end of gauge (right) 1.
3. Adjusting the gauge
1
2
5
A
7
Center of needle
2
3
−
3
4
D
A'
C
1) Normally,the height of gauge 1 should be adjusted
to 20 to 23 mm (0.78" to 0.906") when the gauge is
raised. To adjust the height of the gauge, change
the engagement between driving gear 2 and driven
gear 3.
2) Only the speed at which the gauge comes down is
controlled. The speed controller for controlling the
controlled. The speed controller for controlling the
speed is mounted on the solenoid value (the fourth
solenoid value as counted from the leftmost one.)
To adjust the speed,open/close the speed
controller.
51
−
3
1
4
D
8
Advertisement
Table of Contents
