Table of Contents
Advertisement
(4) Adjusting the stacker
(Caution) The stacker provided for this device automatically computes the timing to stack the
garment regardless of its size and atacks the garments on the stacking board as long as
its dimensions are about 180 mm wide or more and 1,000 mm long or shorter. (The stacker
does not actuate under the long-material mode or the finished garment mode).
Approximately 140 garment bodies (material: T/C broad cloth) with a folded top center
plait can be stacked.
1) If the garment bodies are stacked on stacking board 3 with its side A shortened,loosen fixing knob 6
and raise stacking board 3. The stacker can also be adjusted by tightening speed controller 9 (turning
speed controller clockwise) of work clamp cylinder 7.
At this time,loosen fixing knob 4, and adjust so that work clamp 1 contacts with the center of stacking
board 3. Then confirm that swing bar 2 does not come in contact with stacking board 3. (If the bar
comes in contact with the board,loosen fixing knob 5, and adjust the height of the stacking board
properly.)
2) If the garment bodies are stacked on stacking board 3 with its side B shortened, lower stacking board
3.
3) The machine is designed to detect the quantity of garments stacked on the stacker using sensor 8
mounted on work clamp cylinder 7. You can make the alarm occur when the quantity of the stacked
garment reaches the desired volume predetermined only adjusting the position of sensor 8 appropriately.
(Even when the alarm occurs,the machine will not stop running.)
(5) Adjusting the knee switch
3
As viewed from above the unit
5
4
9
8
7
1
2
3
4
−
1
2
A
3
1) Loosen screw 2 in the switch fixing plate 1, and
adjust the stroke of the knee switch.
2) Now,confirm that presser plate 4 stops when
stopper 3 is reached without fail.
9
−
B
6
Advertisement
Table of Contents
