Winding The Bobbin Thread; To Wind A Bobbin While The Sewing Machine Is Performing Sewing; To Wind A Bobbin Independently - JUKI ACF-164-1903 Engineer's Manual

(3) Winding the bobbin thread

1) To wind a bobbin while the sewing machine is performing sewing

2) To wind a bobbin independently

PATTERN No.
X SCALE
Y SCALE
SPEED
COUNTER
WINDER
SELECT
7) Press the sewing machine start switch
rotates and bobbin thread winding is started.
8) To stop the operation, press again the sewing machine start switch
press any key on the control box of LK.
9) To return to the normal sewing, press again
"WINDER" with
SELECT
10) At this time, a display as shown below is indicated on the operation panel of ACF. Then press
switch on the operation panel of ACF.
＊ Sewing machine start switch
＊ Buttons cannot be fed during bobbin winding operation.
＊ When the operating method of operation panel of ACF is "Automatic operation" (P.34) or "Manual
operation" (P.35), the sewing machine start switch
aforementioned operations of steps 4), 5) and 6). Perform the operations of steps 9) and 10) once to set
the operating method of the operation panel of ACF to "Independent operation" mode (P.35), and
perform the operations of the aforementioned steps 4), 5) and 6).
Sewing machine
start switch on
operation panel of
ACF
READY
on the operation panel of ACF. Then the sewing machine
READY
key and press again
READY
14 ＊＊＊＊＊ LK NOT READY ＊＊＊＊＊＊＊
LK CHECK → RESET → START
does not work for two seconds after stop of bobbin winding operation.
−
Thread the bobbin winder and wind the bobbin thread
onto the bobbin as illustrated in the figure.
1) Pull out the thread from the needle.
2) Winding a bobbin is performed at the position of
the origin of the sewing machine. Be sure to remove
the button from the button clamps.
3) Set the operation panel of ACF to "Independent
operation" mode. (P.35)
4) Press key on the control box of LK to make the
READY
sewing LED go out.
5) Select "WINDER" with the
box of LK.
6) Press again key to light the sewing LED. At this
READY
time, a display as shown below is indicated on the
operation panel of ACF.
＊＊＊＊＊ BOBBIN WINDING MODE ＊＊＊＊＊
LK BOBBIN SW OFF
key on the control box of LK, select the item other than
key to light the sewing LED.
does not work even when performing the
16
−
key on the control
SELECT
on the operation panel of ACF or