Table of Contents
Advertisement
4. Button guide
R1
5. Adjusting the height of the feeder bowl
6. Adjusting the position of the feeder bowl
R
4
1
2
3
R2
3
2
1
Feeder bowl
attaching screw
Appropriate clearance R1 between the button guide
1 and the button is approximately 3 to 4 mm (0.118"
to 0.157"). Loosen screw 2, and adjust the clearance
to the correct value. A clearance which is larger than
the value twice as thick as a button by approximately
0.7 mm should be provided between overflow
prevention plate 3 and the button. Loosen screw 2,
and adjust the clearance to the correct value.
Appropriate clearance R 2 between lower surface of
the button guide and the track surface of the feeder
bowl is 0.3 to 0.5 mm (0.012" to 0.020").
Loosen six locknuts 1 of feeder base 2, and adjust
height difference R between the outlet for buttons and
the disk to 0.5 mm (0.020") or less while the disc is
positioned higher than the outlet for buttons. (At this
time, never adjust 3.)
If an excessive difference in height is provided, two
buttons may enter the notch of the feed plate with
overlapped. So be careful.
Adjust clearance R between the feeder bowl and the
disk 4 to approximately 1 to 1.5 mm (0.039" to 0.059").
Loosen nut 1 (above figure) and move the entire unit
of the parts feeder until it is properly positioned. The
position of the feeder bowl can be finely adjusted by
loosening the feeder bowl attaching screw and
changing the position of the feeder bowl.
68
−
−
Advertisement
Table of Contents
