Table of Contents
Advertisement
2
5
4
3
4
5
2. Adjusting the stacking length of cloth (See the configuration on page 53.)
Side A
3. Adjusting the position of the sensor (See the configuration on page 53)
1) If cloth presser sensor 8 is set at the position where the indicator lamp of the sensor lights up when
cloth presser bar 1 moves toward stacking board 3, the sensor produces an alarm sound. In this
case, the sensor detects the stacking amount of garment bodies on the stacking board and products an
alarm sound only, and the device does not stop.
(Caution) The sensor does not produce an alarm sound immediately after the sensor detects the
stacking amount of garment bodies. The alarm occurs when the sewing machine sews
the next garment body.
2) Swing bar sensor !0 detects swing bar 2 that has moved in the direction of the arrow. The sensor
determines the returning timing of the swing bar by detecting the aforementioned state of the swing bar.
Consequently, it is necessary to adjust the stroke of swing bar 2 by changing the position of the
sensor. (Adjust the sensor of long materials are to be used. Moving the sensor in the direction of the
arrow will lengthen the stroke of the swing bar. In this case,however, be sure to confirm that the indicator
lamp of swing bar sensor !0 lights up.)
1
6
3
1
2
6
Side B
3) At the same time when conveyor 1 goes up, swing
bar 2 spreads the other end of cloth 5. This will
stack the cloth on stacking board 4.
4) After stacking cloth 5, swing bar 2 returns to the
home position. Then, cloth presser bar 3 returns
to the home position.
If the cloth on A side is shorter (longer) than the cloth
on side B, perform the following adjustment.
1) Loosen fixing knob 6 of the stacking board,and
raise (lower) stacking board 3.
2) Turn speed controller !1 of cloth presser cylinder
7 clockwise (counterclockwise) to decrease
(increase) the speed.
(Caution) If the speed is unnecessarily increased,
the stacker will generate an impact noise
and durability of the stacker will be
shortened. So, it is recommended not
to increase the speed excessively.
If the garment body to be stacked is
short, raise stacking board 3 and cloth
presser bar 1.
54
−
−
(The height of the speed
controller has been factoy-
adjusted to 12 mm at the time
of delivery.)
Advertisement
Table of Contents
