Table of Contents
Advertisement
5) Checking the contour of a sewing pattern
FORWARD
BACK
Details of the sewing pattern at the sewing start
™ 1st stitch is a jump stitch and the needle does
not enter.
™ 2nd, 3rd and 4th stitches are tie stitches.
Needle enters in the same button hole.
3rd stitch
2nd and 4th stitches
1st stitch (jump feed)
Needle does not enter.
Needle entry origin
After 5th stitch
−
1) Set the mode to "Independent operation" mode with
the operation panel of ACF. (P.35)
2) Press the button feeding switch (P.4) on the BR
control box, and place a button in button clamps 1.
(See P.14.)
3) When the knee switch (P.4) is turned ON, button
clamps 1 come down. (See P.14.)
4) Holding the knee switch ON, press the
the LK control box, and the button clamps move by
one stitch
If the
key is pressed even one time, the button
FORWARD
clamps do not go up even when the knee is released
from the knee switch.
In addition, After the
the
key becomes effective as well.
BACK
5) Turn the hand pulley to lower the needle and
confirm that the needle enters the hole of the button.
(Caution) When the hand pulley is turned, E3 of
the digital display on the LK control box
is displayed. When the E3 is displayed,
and
FORWARD
make
FORWARD
the hand pulley, raise the needle up to
its up-stop position and make E3 go out.
6) After confirmation of the needle entry position, prees
the
R
key on the LK control box. The button
RESET
clamps return to the origin and go up.
(Caution) At this time, if E3 is displayed, the
key becomes ineffective. To make the
R
key effective, turn the hand pulley,
RESET
raise the needle up to its up-stop
position and make E3 go out.
＊ Buttons cannot be fed during confirmation of the
needle entry position. When feeding the buttons
again, press the
R
RESET
to the origin.
15
−
key on
FORWARD
key has been pressed,
FORWARD
keys are ineffective. To
BACK
and
keys effective, turn
BACK
key to return the button clamps
R
RESET
Advertisement
Table of Contents
