Table of Contents
Advertisement
2 In the case of sewing garment bodies of ladies' wear (set Men's/Ladies' mode selective switch !0
mounted on the right-hand side of the operation panel to its upper side.) (See p.4.)
™ Adjusting distance B
B
™ Dimension B can also be adjusted in the following procedure.
(Caution) In this case, perform the adjustment after changing over the operation mode from the
ladies' wear sewing mode to the men's wear sewing mode.
Move gauge 1 for ladies' wear supplied with the machine toward the right-hand side of setting plate, right
2. Then sewing is carried out in the order from the button that is closest to the bottom edge of the garment
body toward the first button at the top.
1) Adjust the seam allowance from the side end of
the garment to the button (distance A in the figure),
B
and from the top end of the garment to the 1st button
(distance B in the figure).
The number of buttons and the intervals between
A
the buttons can be adjusted using the panel
switches. (Refer to "Inputting the sewing data" on
page 28.)
(Caution) Be sure to make adjustment of the seam
2) Adjust dimension A for ladies' wear should be
adjusted following the same procedure as that for
men's wear.
Insert gauge 1 for ladies' wear supplied with the
machine into setting plate,right 2. Then shift the setting
plate to the right or left according to scale value 3
1
2
desired.
3
7
−
−
allowance after you have turned OFF the
power switch.
2
1
Advertisement
Table of Contents
