Table of Contents
Advertisement
4. Operating timing of the stacker under the automatic stacking mode
1) Material of which length is larger than 600 mm
600 mm
Sensor2
2) Material of which length is smaller than 600 mm
Sensor2
600 mm
5. Operating timing of the stacker under the manual stacking mode
600 mm
Sensor2
1) For materials of which length is larger than 600 mm.
While the material is being fed in the direction of
the arrow, the length of time required from the time
when the front end of the material passes sensor 2
(solid line) to the time when the rear end of the
material passes sensor 1 (two-dot chain line) is
measured. The material length is calculated based
on the aforementioned length of time measured.
Sensor1
2) For materials of which length is smaller than 600 mm.
While the material is being fed in the direction of
the arrow, the length of time required from the time
when the rear end of the material passes sensor 1
(solid line) to the time when the front end of the
material passes sensor 2 (two-dot chain line) is
measured. The material length is calculated based
on the aforementioned length of time measured.
3) The length of time during which the conveyor rotates
should be specified in accordance with the material
length calculated in the aforementioned steps 1)
Sensor1
and 2).
When the conveyor stops rotating, the cloth presser
bar actuates.
Length if time during which the conveyor rotates (a
value on the timer) is specified regardless of the
material length.
After the conveyor stops rotatong,the cloth presser bar
actuates.
A value on the timer can be set to any of twenty steps
ranging from level 1 (0.6 sec.) to level 20 (2.1 sec.). It
is specified on the operation panel.
(Operate the stacker under the manual stacking mode
Sensor1
if long materials are to be used or light-weight materials
or black-coloured materials that cannot be detected
by the sensor are to be used.)
55
−
−
Advertisement
Table of Contents
