Table of Contents
Advertisement
2 Sewing operation
Operation example : After performing sewing with the contents of the registered P1, perform sewing with the
contents of P3.
READY
P 1
READY
P 3
4) Adjusting the position of the button clamps
1
Button
Needle entry position
7) When the center of the needle is not in the center of the button, loosen setscrews 2 in the button clamp
unit and adjust so that the center of the needle is in the center of the button.
8) After the adjustment, turn the hand pulley to return the needle to its up-stop position. Then E3 of the
digital display goes out and the button clamps 1 go up.
9) Press again the button feeding button on the BR control box, place a button again and perform the step of
checking the contour of a sewing pattern (P.15). Then confirm that the needle surely enters the hole in the
button.
SEWING
SEWING
2
Holes in the button
14
−
1) Turn ON the power switch.
P 1
2) Press the
key.
3) Press the
key, and when the sewing LED lights
READY
up, the work clamp foot goes up after it has moved.
4) Check the contour of the sewing pattern.
(Refer to the item "Checking the contour of a sewing
pattern".)
5) If the contour of the sewing pattern is acceptable,
the sewing can be made.
6) After the completion of sewing, press the
Then the work clamp foot will move to the sewing
start point after the origin retrieval. The P keys can
operate the pattern change by one-touch even
when the sewing LED is lighting up.)
7) Perform the above items 4) and 5).
The P1 to P7 keys can be indicated on the display
when selecting the pattern by pressing the
key.
BACK
→ 0 to 99 ←→ P1 to P7 ←
P1 to P7 which have not been registered are not
indicated.
1) Set the mode to "Independent operation" mode
(P.35) with the operation panel of ACF.
2) Press the button feeding switch (P.4) on the BR
control box, and place a button in button clamps 1.
3) When the knee switch (P.4) is turned ON, button
clamps 1 come down.
4) Holding the knee switch ON, turn the hand pulley until
the digital display on the LK control box becomes E3.
5) Release the knee from the knee switch.
6) Further turn the hand pulley to lower the needle
and confirm that the center of the needle is in the
center of the button.
(Caution) If the needle is returned to the up-stop
position when turning the hand pulley,
E3 of the digital display on the LK
control box will disappear, and the
button clamps 1 will go up.
−
P 3
key.
or
FORWARD
Advertisement
Table of Contents
