Section 2 Operations - GE Compax 40E System Service Manual

Table of Contents

Advertisement

GE HEALTHCARE
REV 9
SECTION 2
OPERATIONS
Note: At the end of each operation of periodic maintenance, the complete "functional tests" procedure must be ap-
plied (refer to Chapter 4 of this manual).
2-1
Table
See SM ref.: 2150299−100, Chapter 6
2-2
MPH Generator
See SM MPH ref.: 2137354−100, Chapter 4.
2-3
XT
See SM 2118733−100, Dir. 2116793−100
2-4
RS 85
See SM 03277223, Chapter 4
2-5
SG60
See SM 2150293−100, Chapter 5
2-6
SG100
See SM 2150297−100, Chapter 5
2-7
Tomo−Link
See SM 2133821−100, Chapter 19
2-8
Collimator
The following PM procedure applies to Ultranet "SM" Collimators. You can also reference the following
directives for this procedure.
SM Y00W21L.04, Chapter 10
SM Y00W20L.04, Chapter 10
2-8-1
Equipment Required for Collimator PM
Standard tools
LUBRIPLATE 630−AA Grease (or equivalent)
Set of wrenches (furnished with the collimator and left on site)
>
Hook wrench for collimator mounting ring (Part No. 45298477)
>
Hex adapter (Part No. 2223142)
>
Two wrenches for 10/32" and 9/16" screws (Part No. 45298477)
>
Two hook wrenches for 25,, castle nuts (Part No. 45298476)
>
One knob position tool (Part No. 2188963)
Set of wrenches (not furnished)
>
Torque wrench (for torquing the mounting ring): 3/8" square drive torque of 20 to 30 Nm (180 to
270 in lbs.)
System Service Manual − SYSTEM COMPAX 40E, CE Marked
with MPH 50/65/80 (including XT, RS 85 and Tomo−Link)
96
DIRECTION 2154260−100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Compax 40E and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Compax 40ce

Table of Contents