GE Compax 40E System Service Manual page 35

GE HEALTHCARE
REV 9
Step
From previous page
DD MPH CONFIGURATION CHECKS
CONFIGURATION
A24
D Re−do MPH necessary Configuration
1 Person
CONFIGURATION
D Re−do necessary Sub−System
Components Configuration
A25
1 Person
RUN−IN & STABILITY CHECK
A26
D Rotating anode Tube
1 Person
Continues on next page
Description
1 Hour
System Service Manual − SYSTEM COMPAX 40E, CE Marked
with MPH 50/65/80 (including XT, RS 85 and Tomo−Link)
Í Í
Mark each box when done
Í Í
Done Supporting Documents
Refer to Inspection Report 2179651 TDR or to
Inspection Report 2167647 TDR, or 2172166 TDR
section 1.3
Í Í
NOTE: Connect Service Terminal as described
Í Í
Refer to Inspection Report 2167647 TDR, or 2172166 TDR
section 4.3 for C40E; section 5.3 for SG; section 6.2 for
RAFL−S
or Refer to Inspection Report 2179651 TDR, section
4.3 for 40E; 6.3 for SG; 7.2 for RAFL−S
Í Í
SG60 SM 2150258−100 (Chapter 2), SG100 SM
2150257−100 (Chapter 2), XT SM 46−019803 or
Í Í
2118910−100 (section 12), RS 85 SM Mounting
Refer to Inspection Report 2179651 TDR or Inspection
Report 2167647 TDR, or 2172166 TDR section 2.2
REMARK: The Run−in & Stability check is
performed at the factory. See Technical
Í Í
Publications, Dir. 46−013804
Í Í
To redo on site ONLY if necessary (refer to
System Inspection Report Completion date).
Use procedure for MVP generators.
24
DIRECTION 2154260−100
See MPH SM 2137354−100, Job Cards
LG001, RG001 and RG002
in Job Card LG 001
See C40E SM 2150259−100 (Chapter 2)
Instructions 0327 7223 (section 3)