Defining Ip Addresses - NBase-Xyplex MAXserver 1608A Getting Started

Valid numerical values consist of the pound-sign character (#) and a number
in the range of 0 through 128. Xyplex load servers respond to the numbers 1
through 5. The following table describes these values.
Numerical Value
1
2 through 4
5
6 through 128
2. Enter a valid filename and press RETURN. The unit returns you to the
Access server Configuration Menu. This completes the configuration of
the access server.
3. If you enabled all image loading protocols or specified TFTP as the
loading protocol, proceed to "Defining IP Addresses."

Defining IP Addresses

If you enabled all image loading protocols or specified DTFTP as the loading
protocol, you must supply a non-zero Internet address for the unit, load host
and gateway (if the load host is not on the same network as the unit.
If Directed TFTP is enabled, the following prompt appears:
ENTER UNIT IP ADDRESS [0.0.0.0]:
0038
Getting Started with MAXserver Access Servers
Table 10 - Image File Naming Conventions
Allows you to specify a load file name via the NCP
commands at a VAX/VMS load server, or via client
entries on a Xyplex loader. This is the default.
Reserved for use by NBase-Xyplex
Requires a load server to ignore the load request --
unless the load server's client database contains a
node entry for the requesting access server. (The
numerical value 5 is useful when you want to require
that a specific load server be used to load the unit.)
Undefined.
Description
99