Unpack And Inspect The Unit; Place The Unit On A Flat Surface Or Mount On Rack - NBase-Xyplex MAXserver 1608A Getting Started

7. Connect the power cord to rear of the unit, then to an AC power outlet,
and observe the front panel lights.
8. Connect the serial device cables to the unit and to the devices (terminals,
PCs, etc.), and initialize the devices.
The following sections provide more detailed installation instructions.

Unpack and Inspect the Unit

Follow these steps:
1. Carefully unpack the unit shipping carton.
2. Inspect the contents and make sure that you received all parts listed on
the shipping order.
3. Place all packing materials back into the shipping carton and save the
carton. (If you need to return the unit to NBase-Xyplex or your
distributor, you should return it in the original carton.)
4. If the unit has been damaged in shipping or any parts are missing, notify
your NBase-Xyplex representative or distributor immediately.

Place the Unit on a Flat Surface or Mount on Rack

Select a location for the unit that meets the following requirements:
Adequate Space -- A standard 19" rack or a 19" x 15" flat, stable surface
such as a shelf or desktop must be available or use the instructions in
Section 2.3.1 to mount it in a standard 19" rack.
You can locate the unit in a variety of environments, including an office or
computer room, provided the environmental requirements are met.
0038
Getting Started with MAXserver Access Servers
21