Figure 32 - The Modify Unit Configuration Menu - NBase-Xyplex MAXserver 1608A Getting Started

To modify the access server configuration, complete the following steps:
1. Type 2 at the "Enter menu selection" prompt of the Access server
Configuration Menu. The unit displays the Modify Unit Configuration
Menu, as shown Figure 32.
Modify Unit Configuration Menu
1. Initialization record #1 (Enabled)
2. Initialization record #2 (Disabled)
3. Initialization record #3 (Disabled)
M. Miscellaneous unit configuration
D. Set unit configuration to defaults
X. Exit to main menu
Enter menu selection [X]:

Figure 32 - The Modify Unit Configuration Menu

2. If you select either 1, 2, or 3 the unit prompts you for a response. The
record number displayed depends on which initialization configuration
(1,2,or 3) you choose to modify):
SET INITIALIZATION RECORD #1 TO DEFAULTS (Y,N) [N]?
SET INITIALIZATION RECORD #2 TO DEFAULTS (Y,N) [N]?
SET INITIALIZATION RECORD #3 TO DEFAULTS (Y,N) [N]?
If you type 'Y' - The unit returns all configuration options to their
factory default values. See Table 1 for the factory default settings.
If you type N - The unit displays one of the following prompts (depending
on which initialization record you choose to modify):
ENABLE INITIALIZATION RECORD #1 (Y,N) [Y]?
ENABLE INITIALIZATION RECORD #2 (Y,N) [Y]?
ENABLE INITIALIZATION RECORD #3 (Y,N) [Y]?
3. Valid answers to this prompt are Y (Yes) and N (No).
'Y' - Enables the specified initialization configuration. Press any key to
return to the Modify Unit Configuration Menu.
0038
Getting Started with MAXserver Access Servers
91