Defining Dumping Methods - NBase-Xyplex MAXserver 1608A Getting Started

M
B (Bootstrap Protocol)
R (RARP
1. Select specific protocol(s) by removing letters from or adding letters to
the brackets. To remove a letter, type the letter and press RETURN.
The prompt reappears, however, the letter you typed does not appear
within the brackets. To add a letter to those within the brackets, type
the letter and press RETURN. The prompt reappears and the letter you
typed is included within the brackets.
2. When the letters within the brackets represent all the protocols you
want to use, press RETURN. The unit then redisplays the prompt
showing the protocols you specified. Press RETURN again. The unit
prompts you to define dumping methods. Proceed to the next section to
continue the configuration.

Defining Dumping Methods

This section describes how to define the unit's dumping methods.. Once you
have selected the parameter loading methods and pressed RETURN, the
unit displays the following prompt:
Enable ALL methods for dumping (Y,N) [Y]?
1. Type Y to select all methods, or type N to select specific method(s). The
valid methods are listed in Table 9. You can select up to four dumping
methods.
96
Getting Started with MAXserver Access Servers
image.
From the MOP -DEC Maintenance Operations
Protocol (DEC MOP) loader protocol.
At a BOOTP/TFTP host.
From Reverse Address Resolution Protocol
(RARP/TFTP).
0038