Updating Images - NBase-Xyplex MAXserver 1608A Getting Started

Get File Name:
Get File Area:
Get File Current
State:
Get File Previous
State:
Parameter Area
Updates:

Updating Images

Use the following command to initiate and terminate flash card load image
updates.
SET SERVER GET CARD [LOADFILE] [" FILE-NAME" ] IP ADDRESS [ IP-ADDRESS ] AREA [ AREA-NUMBER ]
Where
LOADFILE
"file-name"
IP ADDRESS
STOP
ETHERNET ADDRESS
0038
Getting Started with MAXserver Access Servers
Name of file.
Area of flash card to put file.
What the card is currently doing.
Did previous GET FILE succeed.
How many times the PARAM Area of the Flash card
was updated since the server was rebooted.
You must re-initialize the unit after updating the
card, if you want to use the new software version
immediately.
ETHERNET ADDRESS [ ETHER-ADDRESS ] AREA [ AREA-NUMBER ]
[STOP]
Loads the image file.
The image's file name. Enclose the name in
quotes.
Location of stored file to GET.
Terminates the file loading process.
Location of the stored file to GET
Means
55