Command Line Interface; Displaying An Initialization Record - NBase-Xyplex MAXserver 1608A Getting Started

Command Line Interface

This section describes the commands you can use to configure the
MAXserver from the command line:
·
Viewing Initialization Parameters
·
Changing the name of the software image file
·
Assigning IP addresses to the network host, access server, gateway, and
the network host where the image file resides
·
Changing the Status of an Initialization Record
·
Enabling and Disabling Protocols
·
Resetting Parameters in Initialization Records to Default Values
See the Commands Reference Guide for a complete listing of all commands.

Displaying an Initialization Record

Use the following command to display an initialization record:
LIST SERVER LOADDUMP [ primary ] CHARACTERISTICS
0038
Getting Started with MAXserver Access Servers
[ secondary ]
[ tertiary ]
107