Initializing Server And Port Parameters; Revert To Stored Configuration - NBase-Xyplex MAXserver 1608A Getting Started

Initializing Server and Port Parameters

The Initialize Server and Port Parameters option instructs the operating
software, once loaded, to use factory default values for all server and port
parameters. All current server and port parameters will be lost when you
exit from the menu (using Option S "Exit saving configuration changes").
1. To select this option, type 3 at the "Enter menu selection" prompt of the
Access Server Configuration Menu (Figure C-1). The server prompts:
WHEN THE SOFTWARE HAS BEEN LOADED, SHOULD
DEFAULT SERVER AND PORT PARAMETERS BE USED (Y,N) [N]?
2. Type Y to use the defaults or N to keep the configuration you created,
then press RETURN. The unit returns you to the Configuration menu.
The parameter initialization takes effect after you exit from the
Configuration menu and the unit loads its image. Changes you have
made through the Access Server Configuration menu take place only
after you exit from the menu, having chosen Option S ("exit saving
configuration changes").

Revert to Stored Configuration

The Revert to Stored Configuration option lets you cancel any changes you
have made without exiting from the menu. The unit reverts to the
configuration values that were last saved. Typically, you would select this
option if you had changed some settings, and then decided to undo the
changes and begin again.
1. To select this option, type 4 at the "Enter menu selection" prompt of the
Access server Configuration Menu (Figure 28). The configuration menu
prompts:
REVERT TO THE STORED CONFIGURATION (Y,N) [N]? Y
104
Getting Started with MAXserver Access Servers
0038