Protocols - NBase-Xyplex MAXserver 1608A Getting Started

Getting Started with MAXserver Access Servers
By default, all available dump protocols and parameter file protocols are
enabled, and all available software load image protocols are enabled except
DTFTP.
The access server attempts to load software using the CARD protocol first,
because this is the default. If a card is not present, it searches for the load
image using protocols in the order they appear on the screen: XMOP, MOP,
BOOTP, RARP, and DTFTP, if it is enabled. When the access server
attempts to send information to a dump server, it first attempts to use
XMOP, then MOP, BOOTP, and RARP.

Protocols

This section describes the dump protocols that you can enable or disable to
send information.
Enabling/Disabling Dump Protocols
The DEFINE SERVER DUMP PROTOCOL command enables or disables
one or all dump protocols. The access server uses a dump protocol to send
information to a dump server.
Use the following command to enable BOOTP as a dump protocol for the
primary record.
XYPLEX>> DEFINE SERVER DUMP PROTOCOL BOOTP ENABLED
Use the following command to disable MOP as a dump protocol for the
secondary record.
XYPLEX>> DEFINE SERVER DUMP SECONDARY PROTOCOL MOP DISABLED
119
0038