Retrieving Image Files From Host; Terminating Image File Loading; Dump Protocols - NBase-Xyplex MAXserver 1608A Getting Started

Retrieving Image Files from Host

Use this command to retrieve a load image from a host on the LAN to a flash
card in an access server, either through TFTP or XMOP (use XMOP to get
the image from another NBase-Xyplex unit).
GET CARD LOAD FILE [ image-name ] ADDRESS [ ip-address ]
"image-name" The name of the updated image file
ip-address
ether-address The Ethernet address where the image file is located.
area-number
Example
GET CARD LOAD FILE "xpcsrv20.sys" 140.179.255.110

Terminating Image File Loading

Use this command to terminate the image loading update that was initiated
with the GET CARD LOAD FILE command.
XYPLEX>> GET CARD STOP

Dump Protocols

Use the following command to enable or disable dump protocols:
DEFINE SERVER DUMP [ RECORD ] PROTOCOL PROTOCOL |ALL
ENABLED|DISABLED
The [record ] variable specifies the primary, secondary, or tertiary
initialization record.
0038
Getting Started with MAXserver Access Servers
The IP address where the image file is located
The area on the flash card where you want to store the file.
AREA [ area-number ]
[ ether-address ] AREA[ area-number ]
AREA 2
113