NBase-Xyplex MAXserver 1608A Getting Started page 101

Enabling/Disabling Status Message Display
To enable or disable loading status messages, complete the following steps:
1. Type M at the Enter Menu Selection prompt on the Access server
Configuration menu and press RETURN. The unit prompts:
DISPLAY LOAD STATUS MESSAGES (Y,N) [Y]:
2. To disable load status messages, enter 'N'. Otherwise, leave the default
(Y) intact.
NOTE: You might want to prevent the unit from generating
Memory Configuration
To configure the amount of memory in the MAXserver, complete the
following steps after enabling/disabling load status messages. The
configuration menu prompts:
TOTAL INSTALLED MEMORY IN MEGABYTES (4,6,8) [4]:
The prompt indicates the amount of installed memory for which the unit has
been configured. If you remove memory, you must change this value.
(Preferably, you should change this value before you remove the memory.)
Also, if you have enabled more software features than the unit can support
with the reduced memory, you will not be able to re-initialize the unit after
you remove the SIMMs. If this happens, you must re-install the SIMMs and
configure the TCP/IP-LAT software image for fewer features.
SIMMs should only be installed or removed by qualified personnel. See the
0038
Getting Started with MAXserver Access Servers
status messages during the software loading process,
if a device such as a bar code reader, which cannot
interpret status messages, is connected to a serial
port.
101