Creating A Customized Configuration - NBase-Xyplex MAXserver 1608A Getting Started

'N' - Disables the specified initialization configuration and lets you
create your own configuration. See "Creating a Customized
Configuration" to continue.

Creating a Customized Configuration

This section explains how to create a custom configuration for the
MAXserver access server. You can customize the following values for up to
three initialization records:
·
Enable all image loading types or only specific methods (e.g., CARD,
DTFTP, RARP)
·
Enable all parameter loading methods or only specific parameter loading
methods (e.g., NVS, XMOP, MOP)
·
Enable all dumping methods or only specific dumping methods (e.g.,
XMOP, TFTP, BOOTP)
·
Define a load file name (if you selected Card, XMOP or MOP loading
methods)
·
Define IP addresses for the unit, host and gateway (if you selected TFTP
as the loading method)
Defining the Image Loading Method
You can change the method the MAXserver uses to load its software. For
example, you can configure the unit to load exclusively from a specific type
of load server or from the flash card only. Use the Access server
Configuration menu to change the software loading method. Alternatively,
you can use DEFINE SERVER commands to change the software loading
method. (See Command Line Interface section of this guide for a description
of the commands you can use at the Xyplex> prompt to display, monitor and
define the unit's configuration.
92
Getting Started with MAXserver Access Servers
0038