NBase-Xyplex MAXserver 1608A Getting Started page 41

If you are trying to telnet from one NBase-Xyplex device into another
NBase-Xyplex access server's console port, the command you will use is:
telnet x.x.x.x:2000
where "x.x.x.x" represents the IP address of the destination access
server. For example, enter telnet 140.179.41.59:2000 to reach the
console port of the server having an IP address of 140.179.41.59.
NOTE: Port# 2000 must be specified when trying to remotely connect
to the access server. If no port/socket number is specified, then
most Telnet applications will use port 23 by default. Unless the
access server's console port has also been redefined to port 23,
any attempts to Telnet into the server's console port will be
refused.
3. When you are connected to the access server, press the Enter key one
more time to display the login password prompt (#).
4. Type the default login password "access" at the # prompt, and press the
Enter key.
NOTE: The password is not echoed as you type.
5. If you entered the password correctly, the Enter username> prompt
will be displayed.
6. Enter any name at the Enter username> prompt, just as if you were
connected locally to one of the serial ports.
The Xyplex> prompt is now displayed.
0038
Getting Started with MAXserver Access Servers
41