Figure 11 - Sample Show Port 0 Telnet Characteristics Display - NBase-Xyplex MAXserver 1608A Getting Started

c. Configure the Subnet Mask for the access server. The subnet mask
must be consistent with the network on which the access server
will reside. Use the following commands:
define server ip subnet mask [ ip-address ]
set server ip subnet mask [ ip-address ]
d. Configure the default first-hop Router/Gateway:
define server ip primary gateway address [ ip-address ]
set server ip primary gateway address [ ip-address ]
2. Specify Telnet Port 2000 when connecting remotely:
Be sure to specify telnet remote port# 2000 when trying to connect. If no
port/socket number is specified, then most Telnet applications will use
port 23 by default. Unless the Xyplex's console port has also been
redefined to port 23, then any attempts to Telnet into the server's
console port will be refused.
The current port setting on the access server is displayed in the "Remote
Port" field of the "show port 0 telnet characteristics" screen. Figure 11
shows a "show port 0 telnet characteristics" screen with the "Remote
Port" field set at 2000.
MX1620>> show port 0 telnet characteristics
Port 0: admin
Abort Output Character:
Attention Character:
Default Port:
Echo Mode:
Erase Keystroke Character:
Erase Line Character:
Interrupt Character:
TerminalType:
Tn3270 TranslationTable:
Local Port:
Enabled Characteristics:

Figure 11 - Sample SHOW PORT 0 TELNET CHARACTERISTICS Display

40
Getting Started with MAXserver Access Servers
None Newline:
None Newline Filtering:
23 Query Character:
Character Remote Port:
None Synchronize Character:
None Transmit:
None Binary Session Mode:
None Tn3270 Device:
None Tn3270 Printer Port:
4000 Tn3270 Default Port:
05 Jan 2000 19:33:48
CR/NULL
None
None
2000
None
BuffTime 80
PASTHRU
None
Any
23
0038