Connect The Power Cable - NBase-Xyplex MAXserver 1608A Getting Started

Connect the Power Cable

You do not need to set the unit for 115V or 230V operation. The power
supply automatically adapts to the input voltage.
A grounded AC power outlet should be located within six feet of the back of
the unit. You can use a UL-approved, 3-prong extension cord if necessary,
provided it has sufficient current and voltage capacity. (The cord must have
sufficient capacity for the input power, and AC power must meet the criteria
listed in).
To connect the power cable, complete these steps:
1. Plug the AC line cord (supplied) into the AC power receptacle on the rear
of the unit. (See Figure 4 for the location of the power receptacle.)
2. Plug the other end of the cord into a grounded 3-prong AC power outlet
(or a UL-approved extension cord with sufficient capacity that is plugged
into a suitable outlet).
3. When you apply power, the unit performs a self test of its circuitry and
then proceeds to load its software. When the unit has finished loading
its software, the RUN light flashes slowly and the LAN light flashes as
Ethernet packets are received. (Figure 6 shows the locations of the
lights on the front panel.)
26
Getting Started with MAXserver Access Servers
0038