Front Panel Leds - Maxserver 1620/1640; Front Panel Leds - Maxserver 1604/1608B; Figure 6 - Maxserver 1620/1640 Front Panel - NBase-Xyplex MAXserver 1608A Getting Started

Front Panel LEDs - MAXserver 1620/1640

The front panels of the MAXserver 1640 and 1620 access servers are
identical, except for the model designation. If, after several minutes, the
front panel lights do not behave as indicated, refer to the Troubleshooting
section of this guide for instructions.
Memory Card slot
Eject Button

Front Panel LEDs - MAXserver 1604/1608B

The front panels of the MAXserver 1604 and 1608B access servers are
identical, except for the model designation (see Figure 7). If, after several
minutes, the front panel lights do not behave as indicated, refer to the
Troubleshooting section later in this guide.
0038
Getting Started with MAXserver Access Servers
CARD
RUN LAN CONSOLE
1 2 3 4 5 6 7 8 9 10
Ports 1 - 10
Flashing = activity on associated ports.
ON = port connection established.
OFF = no port connection established.
Reset switch
Press again to re-initialize the unit.
CONSOLE light
unit's console port via the network. Flashes if permanent
parameter changes have not yet been stored. (Do not power
off the unit while this light is flashing.)
LAN light
packets. Rapid blinking indicates heavy network traffic to the
unit.(OFF when not connected to network, or network is faulty.)
RUN light
unit executes firmware code; flashes slowly when software
is loaded (RUN state).
CARD light
Do not remove the card or power off the unit while this
light is ON.

Figure 6 - MAXserver 1620/1640 Front Panel

XYPLEX MAXSERVER 1620
TERMINAL SERVER
-- These lights indicate port activity.
-- Press once to put the unit in reset state.
-- ON when someone is logged on to the
-- Flashes when the unit receives Ethernet
-- ON when unit is reset; flashes rapidly when
-- ON when Memory card is being accessed.
27