Loading Protocols - NBase-Xyplex MAXserver 1608A Getting Started

DEFINE SERVER LOAD STATUS MESSAGE [ENABLED]
Where
ENABLED
DISABLED
Example
DEFINE SERVER LOAD STATUS MESSAGE DISABLED

Loading Protocols

The default protocols are tried in the following order: Flash Card,, Directed
TFTP, XMOP, BOOTP/TFTP, MOP, and RARP/TFTP. The protocols are:
·
Flash Card - For MAXservers, use FlashCard (card) to load image only.
·
Use XMOP for loading from a NBase-Xyplex load server.
·
Use MOP for loading from a VAX/VMS host.
·
Use BOOTP, RARP, and DTFTP (Directed Trivial File Transfer Protocol)
for loading from a UNIX host. Typically, you only need to use DTFTP
when loading across a router or when the load host does not support
BOOTP or RARP.
You can change the default value for many prompts. The first time you run
the Configuration Menu, the default value shown is the factory default
value. After you exit from the Configuration Menu, having saved changes,
82
Getting Started with MAXserver Access Servers
Means
Status messages display during the loading process. This
is the default.
Status messages will not display during the loading
process.
[DISABLED]
0038