Displaying Initialization Records; Figure 29 - Display Unit Configuration Menu - NBase-Xyplex MAXserver 1608A Getting Started

To Display the Unit Configuration Menu, complete the following steps:
1. Type 1 at the "Enter menu selection" prompt on the Access server
Configuration Menu and press Return. The unit displays the Display
Unit Configuration Menu, as shown in Figure 29.
Display Unit Configuration Menu
1. Initialization record #1 (Enabled)
2. Initialization record #2 (Disabled)
3. Initialization record #3 (Disabled)
M. Miscellaneous unit configuration
X. Exit to main menu
Enter menu selection [X]:

Displaying Initialization Records

When you initialize a MAXserver Series access server, it obtains the
software load imageand parameter file using the information in an
initialization record. The for the access server maintains three initialization
records. The access server first attempts to load software using the
information in the primary initialization recordif it is enabled. If it cannot
load successfully, it attempts to load using the information in the secondary
initialization record, if it is enabled. If this fails, it attempts to use the
information in the tertiary initialization recordif it is enabled. If all three
attempts fail, the access server begins this sequence again with the primary
initialization record.
You can create up to three unique "initialization configurations" (also called
initialization records), numbered 1 (primary), 2 (secondary), and 3 (tertiary).
(In this case, initialization refers to loading both image and parameters.)
If for any reason there are no service offers for loading and/or dumping made
as a result of the first (primary) initialization configuration, the unit will try
the secondary initialization configuration. If there are no service offers from
that configuration, the unit will try the third (tertiary) initialization
0038
Getting Started with MAXserver Access Servers

Figure 29 - Display Unit Configuration Menu

85