Changing The Telnet Remote Port; Passwords - NBase-Xyplex MAXserver 1608A Getting Started

Changing the Telnet Remote Port

While you are logged into a port in privileged mode, you can change the
telnet remote port on port 0 from 2000 to 23. Use the following commands:
define port 0 telnet remote 23
logout port 0
Now you can telnet to the IP without a socket number.

Passwords

The following passwords are the defaults the first time you use the
MAXserver.
·
To log on to the server at the # prompt, the default login password is
ACCESS.
·
To set privileged mode at the Xyplex> prompt, the default privilege
password is SYSTEM.
These passwords prevent persons who do not know them from accessing the
server. Change the default passwords to other values as part of your basic
server setup.
If you change the default password, make sure that the new
password is written down in a safe location. If you forget
the password, the server will need to be reset to factory
default settings.
42
Getting Started with MAXserver Access Servers
IMPORTANT
0038