Resetting The Unit's Load And Dump Protocols To Factory Defaults - NBase-Xyplex MAXserver 1608A Getting Started

instructions later in this guide to install and remove SIMM modules.
The unit automatically detects added memory. Therefore, you do not need to
increase the "installed memory" value when you install additional memory.
If you want to increase the value, install the additional memory first. If you
do, the unit will generate the following warning message:
WARNING:
TURN THE UNIT OFF AND INSTALL THE ADDITIONAL MEMORY
SPECIFIED (X MB).
(TYPE ANY KEY TO CONTINUE)
NOTE: This message displays only while you are using the
Configuration menu.
Also, the MAXserver front panel lights will flash an error code the next time
the unit is initialized, if you have not yet installed the memory.
2. Press any key. The unit returns you to the Modify Unit Configuration
Menu.

Resetting the Unit's Load and Dump Protocols to Factory Defaults

The "Set Unit Configuration to Defaults" menu option lets you reinitialize all
of the unit's initialization records to the factory default settings. See Table 5
for the factory default settings.
NOTE: This option will not reset the server and port parameters to
default values. (See "Initializing Server and Port
Parameters" for information on resetting the the server and
port parameters to default values.)
102
Getting Started with MAXserver Access Servers
AFTER SAVING THE NEW CONFIGURATION, YOU MUST
0038