NBase-Xyplex MAXserver 1608A Getting Started page 124

attached console port device.
5. Set up the flow control for the destination port:
DEFINE/SET PORT < port-number > FLOW CONTROL < flow-control-setting >
The flow control setting must match the flow control setting on the
attached console port device.
6. Enter the following command to specify the number of bits per character
for data characters that are transmitted and received over the
destination port:
DEFINE/SET PORT < port-number > CHARACTER SIZE < character-size >
The character size setting must match the character size setting on the
attached console port device.
7. Enter the following command to specify the number of stop bits to be
used on the destination port:
DEFINE/SET PORT < port-number > STOP BITS < bit-value >
The stop bits setting must match the stop bits setting on the attached
console port device.
8. Enter the following command to specify the parity for the destination
port:
DEFINE/SET PORT < port-number > PARITY < parity-setting >
The parity setting must match the parity setting on the attached
console port device.
124
Getting Started with MAXserver Access Servers
0038