NBase-Xyplex MAXserver 1608A Getting Started page 32

NOTE: Access servers do not autobaud when the port receives 7-bit
characters with EVEN parity from the device until
software loading has completed. You must use 8-bit
characters with parity set to NONE in order to receive load
messages and to enter into the ROM Configuration Menu.
You can only enable AUTOBAUD at a port set to local access and when the
attached device is configured with the following settings:
CHARACTER SIZE
PARITY
SPEED
To autobaud the serial port, when your terminal is powered on, keep
pressing RETURN until the unit recognizes the terminal. When you do this,
the serial port adjusts to the communication speed of the terminal. (This
process is called autobauding.)
32
Getting Started with MAXserver Access Servers
8, (7 if EVEN parity)
NONE (EVEN if character size is set to 7)
Valid speeds between 50 and 38400. The
supported port speeds are: 50, 75, 110, 134, 150,
300, 600, 1200, 1800, 2000, 2400, 4800, 9600,
14400, 19200, 21600, 26400, 28800, 33600, and
38400 bits per second (baud). The device
connected to the port must be set to one of these
speeds. (Ports cannot autobaud at port speeds
above 38400 bps.
0038