Beckhoff TwinSAFE EL6910 Operation Manual page 61

Toolbar TwinCAT Safety
Icon Name
Verify Safety Project
Verify Complete Safety
Project
Download Safety Project
Delete Safety Project
Show Online Data of Safety
Project
Customize Safety Project
Toolbar TwinCAT Safety CRC
Icon Name
CRC Toolbar Left-click on the toolbar to initiate an update of the CRCs by the user.
CRC Toolbar Green icon: All CRCs are identical
Online CRC CRC of the safety project on EL6910/EJ6910. This value is read online
Downloaded
CRC
Offline CRC CRC of the current safety project, as stored in the safety editor. A CRC
4.4.6.17 Checking the TwinSAFE addresses
The hardware addresses of the alias devices used can be checked and set via the dialog Check Safe
Addresses.
To this end, select the entry Check Safe Addresses via the node menu of the safety project node. A dialog
opens, which lists all alias devices that use hardware addresses. The addresses set in the software (Safe/
FSoE Address) and the hardware addresses (Hardware Address) are shown in separate columns for each
alias device and for the target system. In the column Take Hardware Address the user can specify whether
the hardware addresses for the alias devices settings are applied when the dialog is closed via the OK
button.
EL6910
Description
The safety project is checked for validity.
The safety project including the hardware level is checked for validity.
Loading the safety project onto the target system, here EL6910/
EJ6910
Deleting the safety project from the target system, here EL6910/
EJ6910
Switching on the Online View for the safety project.
Customizing the safety project (switching off TwinSAFE groups and
setting of safe substitute values for the group outputs). This is possible
if the online and offline CRC are the same and at least one group has
been configured for customizing.
Description
Red icon: CRCs are different
by the EL6910/EJ6910. In the absence of an ADS connection to the
EL6910/EJ6910, this value is displayed with
CRC of the safety project that was loaded last. If no safety project is
loaded when the TwinCAT project is opened, the value is displayed
with .
is displayed, if the stored project is valid. If the project is invalid,
is displayed as CRC.
Version: 1.8.0
Operation
.
61