Bfm#29] Error Code; Bfm#30] Fx Series Model Code; Bfm#59, #58] Current Address (Pulse Converted Value) - Mitsubishi Electric MELSEC-F Series User Manual

FX -1PG User's Manual
3U
7.5.3

[BFM#29] Error code

An error code is stored at the time of the error occurrence.
BFM No.
High order Low order
16bit 16bit
- #29
*1. represents the BFM number for which there is an error.
Point
After removing the cause of the error, clear the error code by turning off the power supply or by the error reset
(BFM#25 b0).
7.5.4

[BFM#30] FX Series model code

The model code of the FX
BFM No.
High order Low order
16bit 16bit
- #30
7.5.5

[BFM#59, #58] Current address (pulse converted value)

Stores the current address data in the pulse converted value.
BFM No.
High order Low order
16bit 16bit
#59 #58
Point
• Stored address is always a pulse conversion value of the absolute address.
• The current address can be changed to any specified address during stop.
When a value is written in the current address (pulse conversion value), the current address (BFM#27,
#26) is also updated.
• The address change during the positioning operation is invalid.
• A value read from the servo amplifier by the ABS instruction (FNC155) of the PLC is the pulse conversion
value. Write in this buffer memory.
→ For the details of the error code, refer to Section 11.2.
Error code
K0 No error.
*1
Large/small relationship is incorrect.
K 1
*1
Setting range is incorrect.
K 3
*1
Setting value overflow error.
K 4
K5 Operation command multiple selection error.
K6 Forward limit/reverse limit error.
K7 Watchdog timer error
-1PG is stored.
3U
The model code of the FX -1PG is K5,130.
3U
-2,147,483,648 to 2,147,483,647 PLS
Description
Description
Description
7 Buffer Memory
7.5 Monitor Data
1
2
R/W Default
R K0
3
4
5
R/W Default
R K5,130
6
R/W Default
7
R/W K0
8
9
10
79