Interrupt Input Via Plc (Bfm) - Mitsubishi Electric MELSEC-F Series User Manual

FX -1PG User's Manual
3U
6.3.3

Interrupt input via PLC (BFM)

In the interrupt 1-speed positioning operation, the interrupt stop operation, the interrupt 2-speed positioning
operation, and the external command positioning operation, interrupt input (INT0, INT1) via PLC (BFM) can
be used.
When interrupt input via PLC (BFM) is used, select a terminal to be used for the interrupt input in the interrupt
input setting BFM#3 (b3, b2), BFM#37 (b3, b2) and turn on operation command II BFM#57 (b1, b0) by the
PLC input.
Interrupt input setting [BFM#3 (b3, b2), BFM#37 (b3, b2)]
BFM#3 or BFM#37
b3
0
0
1
1
Point
Interrupt input via PLC (BFM) will be used for INT0 and INT1.
The DOG terminal and STOP terminal of the FX
Operation command ΙΙ (BFM#57)
BFM No.
#57
Point
Connect and link an arbitrary input of the PLC (X000, X001, etc.) to the INT0 (b0), INT1 (b1) of the operation
command II (BFM#57).
Response time
Response time of INT0, INT1 is as follows.
• During operation at 1 kHz or higher: within 3 ms
• During operation at less than 1 kHz: within 3 pulses
Caution of interrupt input is used
When both INT0 and INT1 are set to ON at the same time in the external command positioning or interrupt 2-
speed positioning, INT0 is effective.
Interrupt input 0 Interrupt input 1
b2
0 DOG
1 DOG
0 INT0
1 INT0
Item
The interrupt input is executed via the PLC (BFM).
b0 INT0
The INT0 turns to ON when b0 = ON.
The interrupt input is executed via the PLC (BFM).
b1 INT1
The INT1 turns to ON when b1 = ON.
6 Before Starting Positioning Operation
The DOG terminal is used for interrupt input 0.
STOP
The STOP terminal is used for interrupt input 1.
The DOG terminal is used for the interrupt input 0.
INT1
Interrupt input 1 (INT1) via PLC is used for interrupt input 1.
Interrupt input 0 (INT0) via PLC is used for interrupt input 0.
STOP
The STOP terminal is used for interrupt input 1.
Interrupt input 0 (INT0) via PLC is used for interrupt input 0.
INT1
Interrupt input 1 (INT1) via PLC is used for interrupt input 1.
-1PG are used for DOG and STOP.
3U
Content
6.3 System Wiring
Content
33
1
2
3
4
5
6
7
8
9
10