Appendix C: Differences With Fx2N-1Pg; Appendix C-1 Differences Of Specification - Mitsubishi Electric MELSEC-F Series User Manual

FX -1PG User's Manual
3U
Appendix C: Differences with FX
This appendix describes the differences between the FX
The following are differences between the FX
FX -1PG with the FX
2N
Change the system or sequence program as needed.

Appendix C-1 Differences of Specification

Differences in specification between FX
Item
Applicable PLC
Number of connectable
units to the main unit
Range
Output
frequency
Positioning
Acceleration
/deceleration
time
Starting time
Drive power
Inner control
supply
3U
-1PG.
3U
-1PG and FX
3U
FX -1PG
3U
FX /FX PLC
3U 3UC
FX PLC: Up to 8 blocks can be extended.
3U
FX PLC: Up to 6 blocks can be extended.
3UC
-2,147,483,648 to 2,147,483,647 (user unit)
1 Hz to 200 kHz
The output pulse frequency (f) of FX
stepwise as follows.
6
f = 24 × 10 / n (Hz)
Where, n: Integer in range of 120 to 24,000,000
Trapezoidal acceleration/deceleration:
1 to 32,767 ms
Approximate S-shaped acceleration/deceleration:
1 to 5,000 ms
Motor system: 1 ms or less
Machine system: 2 ms or less
5 V DC Current consumption 150 mA
(Power is supplied through the extension cable
from the PLC.)

Appendix C: Differences with FX2N-1PG

Appendix C-1 Differences of Specification
-1PG
2N
-1PG and the FX
3U 2N
-1PG and the FX -1PG. Be careful when replacing the
2N
-1PG are shown in the following table.
2N
FX /FX /FX
2N 2NC 3U
FX PLC: Up to 8 blocks can be extended.
2N
FX 2NC PLC: Up to 4 blocks can be extended.
FX PLC: Up to 8 blocks can be extended.
3U
FX (D, DS, DSS) PLC: Up to 8 blocks can be extended.
3UC
FX -32MT-LT(-2) PLC: Up to 7 blocks can be extended.
3UC
-999,999 to 999,999 (user unit)
10 Hz to 100 kHz
-1PG is The output pulse frequency (f) of FX
3U
follows.
6
f = 1 × 10 / 0.25n (Hz)
Where, n: Integer in range of 40 to 400,000
Trapezoidal acceleration/deceleration:
50 to 5,000 ms
1st time: 500 ms or less
2nd time and later: Approximately 10 ms
5 V DC Current consumption 55 mA
(Power is supplied through the extension cable from the
PLC.)
-1PG.
FX -1PG
2N
/FX PLC
3UC
-1PG is stepwise as
2N
129
11
A
B
C